DIY Toothbrush Holder Design and Print

okay The problem is, I have no place for toothbrushes, so I'm taking the

measurements now and putting them into Fusion 360. First, I'm drawing the

measurements and duplicate design four times I want to put toothbrushes. I erase the drawing

to make holes about 10 centimeters or about four inches. Add a bottom on, so the toothbrushes

don't fall down, but makes hole in them so the water does run down. Now,

to make the part that holds the wall, I'm making two holes and two hooks to the main body for

the toothbrush holder. Am.... I'll make the body just slightly smaller, because it's got

big. Then we're waiting. I'm about to see if it's fit. Okay.