Conductometric Titration Procedure

Prepare the solution Take a known volume of the solution to be titrated (e.g., acid or base).

Add distilled water Dilute it if needed so that the electrodes are fully dipped. Insert conductivity

cell Place the conductivity electrodes into the solution. Set up the conductivity

meter Switch on the conductometer and note the initial conductivity. Add titrant in small

portions Add the titrant (acid or base) from a burette in small, equal amounts.

Stir the solution After every addition, stir the solution to mix it properly. Record conductivity

Note the conductivity after each addition of titrant. Continue until after the equivalence

point Take readings before and after the end point to get a clear graph.